

Note1) : Should be adjusted seatback and (or) seat pumping (if equipped) properly.
Note2) : The seating position (number 5) is not suitable for fitment of child restraint system with support leg.
Note3) : For fitment of ISOFIX toddler’s rearward facing large CRS
- Driver’s seat : Seat pumping should be adjusted to appropriate height.
- Front passenger seat : Seat sliding should be adjusted to appropriate position.
❈ Never place a rearward facing Child Restraint System on the front passenger seat, unless the passenger air bag is deactivated.
❈ It is recommended to remove the head restraint, when CRS is unstable due to head restraint


When not using the ISOFIX system, all Child Restraint Systems must be secured to a rear seat with the lap part of a lap/shoulder belt. Installing a Child Restraint System with a lap/shoulder belt To install a Child Restraint System on the rear seats, do the following: 1.
(Information for vehicle users and CRS manufacturers) Yes : Suitable for fitment of the designated category of CRS No : Not suitable for fitment of the designated category of CRS “-” : Not applicable The table is based on LHD vehicle.
You should exercise the utmost care to prevent damage to your vehicle and injury to yourself whenever performing any maintenance or inspection procedures. Inadequate, incomplete or insufficient servicing may result in operational problems with your vehicle that could lead to vehicle damage, an accident, or personal injury.
1. Open the hood. 2. Remove the bulb socket-connector by turning it counterclockwise. 3. Remove the bulb from the lamp assembly. 4. Install a new bulb. 5. Connect the bulb socket-connector. Headlamp bulb WARNING Halogen bulbs Halogen bulbs contain pressurized gas that will produce flying pieces of glass if broken.