
In order for FCA system to operate properly, always make sure the sensor is clean and free of dirt, snow, and debris.
Dirt, snow, or foreign substances on the lens may adversely affect the sensing performance of the sensor.
Warning message and warning light

When the camera is blocked with dirt, snow, or debris, FCA operation may temporarily stop. In this case, the warning message appears to warn the driver.
This is not a malfunction with FCA. To operate FCA again, remove the foreign substances.
WARNING
FCA system may not activate without any warning messeges according to driving condition, traffic on the road, weather, road condition, etc.
NOTICE
In an urgent situation, the braking system enters into the ready status for prompt reaction to assist the driver in depressing the brake pedal. FCA provides additional braking power for optimum braking performance, when the driver depresses the brake pedal during FCA operation.
When FCA is not working properly, FCA warning light () will illuminate and the warning message will appear for a few seconds. After the message disappears, the master warning light () will illuminate.
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels aligned again. However, if you notice unusual tire wear or your vehicle pulling one way or the other, the alignment may need to be reset.
1. Tail lamp (Bulb type) 2. Tail and stop lamp (Bulb type) 3. Rear turn signal lamp (Bulb type) 4. Back-up lamp (Bulb type) 5. Tail lamp (LED type) 6. Stop lamp (LED type) 7. License plate lamp (Bulb type) 8. High mounted stop lamp (Bulb or LED type) 9.