11. Immediately drive approximately 7~10 km (4~6 miles or, about 10min) to evenly distribute the sealant in the tire.
CAUTION
Do not exceed a speed of 80 km/h (50 mph). If possible, do not fall below a speed of 20 km/h (12 mph). While driving, if you experience any unusual vibration, ride disturbance or noise, reduce your speed and drive with caution until you can safely pull off of the side of the road. Call for road side service or towing.
When you use the Tire Mobility Kit, the tire pressure sensors and wheel may be stained by sealant. Therefore, remove the tire pressure sensors and wheel stained by sealant and we recommend that inspect at an authorized Kia dealer.
1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast.
1. After driving approximately 7~10 km ( 4~6 miles or about 10 minutes), stop at a suitable location. 2. Connect connection hose (10) of the compressor directly to the tire valve.
1. Open the hood. 2. Remove the bulb socket-connector by turning it counterclockwise. 3. Remove the bulb from the lamp assembly. 4. Install a new bulb. 5. Connect the bulb socket-connector. Headlamp bulb WARNING Halogen bulbs Halogen bulbs contain pressurized gas that will produce flying pieces of glass if broken.
1. Using a flat-blade screwdriver, gently pry the lens cover from lamp housing. 2. Remove the bulb by pulling it straight out. 3. Install a new bulb in the socket. 4. Align the lens cover tabs with the lamp housing notches and snap the lens into place.