Kia Soul: Wipers and washers / Heated washer nozzle (if equipped)
The heated washer nozzle function defreeze the washer nozzles in freezing weather.
The heated washer nozzle will turn on and off automatically when the ignition switch is in ON or when the engine is running in following conditions:
- Turns ON when the outside temperature is below 5°C, and OFF when it is over
10°C.
- The washer fluid defreezing speed may be slower when the ignition is in ON, than
compared to when the engine is running.
- When the ignition is in ON, after 20 minutes of operation, the system will turn
off automatically to prevent possible battery discharge.
- After the engine is running, the washer fluid will defrost after 5 to 10 minutes.
- If the engine has been started within the operating temperature, the heated nozzle
remains ON even after 20 minutes.
NOTICE
In below conditions, the heated washer nozzle may not function properly.
- The washer fluids in the washer reservoir is frozen.
- Outside temperature sensor is malfunctioning.
Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer. 1. HI / 2 - Normal wiper ...
Interior light
CAUTION Do not use the interior lights for extended periods when the engine is not running. It may cause battery discharge. WARNING Do not use the interior lights when driving in the dark. Accidents could ...
Other information:
Kia Soul (SK3) 2020-2024 Owners Manual: Floor mat anchor(s)
When using a floor mat on the front floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward. When installing floor mat 1. Align fixing structure (hook) of floor carpet and hook ring of floor mat. 2. Insert the floor mat hook ring ...
Kia Soul (SK3) 2020-2024 Owners Manual: High mounted stop lamp (bulb type) bulb replacement
1. Open the tailgate. 2. Remove the cover. 3. Loosen the retaining bolts and remove the hose (1). 4. Pull out the module from the high mounted stop lamp assembly by pulling both clips. 5. Replace the bulbs by pulling it out. 6. Reinstall in the reverse order. ...
