
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer.
1. HI / 2 - Normal wiper operation
2. LO / 1 - Intermittent wiper operation (if equipped)
3. OFF / O - Wiper is not in operation

Push the lever away from you to spray rear washer fluid and to run the rear wipers 1~3 cycles. The spray and wiper operation will continue until you release the lever.
In the OFF (O) position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty.
The heated washer nozzle function defreeze the washer nozzles in freezing weather. The heated washer nozzle will turn on and off automatically when the ignition switch is in ON or when the engine is running in following conditions: - Turns ON when the outside temperature is below 5°C, and OFF when it is over 10°C.
Wheel replacement When replacing the metal wheels for any reason, make sure the new wheels are equivalent to the original factory units in diameter, rim width and offset. WARNING A wheel that is not the correct size may adversely affect wheel and bearing life, braking and stopping abilities, handling characteristics, ground clearance, body
1. Open the tailgate. 2. Remove the cover. 3. Loosen the retaining bolts and remove the hose (1). 4. Pull out the module from the high mounted stop lamp assembly by pulling both clips. 5. Replace the bulbs by pulling it out. 6. Reinstall in the reverse order.