
In the OFF (O) position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wiper operation will continue until you release the lever.
If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.
The reservoir filler neck is located in the front of the motor compartment on the passenger side.
CAUTION
To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.
WARNING
Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on the windshield and obscure your vision.
CAUTION
Operates as follows when the ignition switch is turned ON. 1. MIST/˅: For a single wiping cycle, move the lever to this (MIST/˅ ) position and release it.
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer.
Follow Normal Maintenance Schedule if the vehicle is usually operated where none of the following conditions apply. If any of the following conditions apply, follow Maintenance Under Severe Usage Conditions. Repeated driving short distance of less than 8 km (5 miles) in normal temperature or less than 16 km (10 miles) in freezing tempera
1. Front turn signal lamp (Bulb Type) 2. Headlamp (Low/High) 3. Position lamp/Daytime running lamp (Bulb Type) 4. Front turn signal lamp (LED Type) 5. Headlamp (LED)/Sub Low 6. Headlamp (LED) (Low) 7. Position lamp/Daytime running lamp (LED Type) 8.