
A: Wiper speed control (front)
1. MIST / ˅ – Single wipe
2. OFF / O – Off
3. INT / --- – Intermittent wipe
AUTO* – Auto control wipe
4. LO / 1 – Low wiper speed
5. HI / 2 – High wiper speed
B: Intermittent control wipe time adjustment
C : Wash with brief wipes (front) *
D : Rear wiper/washer control *
6. HI / 2 – Continuous wipe
7. LO / 1 – Intermittent wipe*
8. OFF / O – Off
E : Wash with brief wipes (rear)
High Beam Assist is a system that automatically adjusts the headlamp range (switches between high beam and low beam) according to the brightness of other vehicles and road conditions.
Operates as follows when the ignition switch is turned ON. 1. MIST/˅: For a single wiping cycle, move the lever to this (MIST/˅ ) position and release it.
If the engine doesn't turn over or turns over slowly 1. Check the battery connections to be sure they are clean and tight. 2. Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is discharged. 3.
1. Using a flat-blade screwdriver, gently pry the lamp assembly from interior. 2. Remove the bulb by pulling it straight out. 3. Install a new bulb in the socket. 4. Install the lamp assembly to interior. CAUTION Be careful not to dirty or damage the lens, lens tab, and plastic housings.