The heated washer nozzle function defreeze the washer nozzles in freezing weather.
The heated washer nozzle will turn on and off automatically when the ignition switch is in ON or when the engine is running in following conditions:
- Turns ON when the outside temperature is below 5°C, and OFF when it is over
10°C.
- The washer fluid defreezing speed may be slower when the ignition is in ON, than
compared to when the engine is running.
- When the ignition is in ON, after 20 minutes of operation, the system will turn
off automatically to prevent possible battery discharge.
- After the engine is running, the washer fluid will defrost after 5 to 10 minutes.
- If the engine has been started within the operating temperature, the heated nozzle
remains ON even after 20 minutes.
NOTICE
In below conditions, the heated washer nozzle may not function properly.
- The washer fluids in the washer reservoir is frozen.
- Outside temperature sensor is malfunctioning.
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer.
CAUTION Do not use the interior lights for extended periods when the engine is not running. It may cause battery discharge. WARNING Do not use the interior lights when driving in the dark.
1. Speed restriction label 2. Sealant bottle and label with speed restriction 3. Filling hose from sealant bottle to wheel 4. Connectors and cable for the battery direct connection 5. Holder for the sealant bottle 6. Compressor 7. On/off switch 8.
11. Immediately drive approximately 7~10 km (4~6 miles or, about 10min) to evenly distribute the sealant in the tire. CAUTION Do not exceed a speed of 80 km/h (50 mph). If possible, do not fall below a speed of 20 km/h (12 mph). While driving, if you experience any unusual vibration, ride disturbance or noise, reduce your speed and drive wi