Kia Soul (SK3): Windshield defrosting and defogging / Manual climate control system

To defog inside windshield

Kia Soul. Manual climate control system

1. Select any fan speed except “0” position.

2. Select desired temperature.

3. Select the Kia Soul. Manual climate control system or Kia Soul. Manual climate control system position.

4. The outside (fresh) air and air conditioning will be selected automatically.

If the air conditioning and outside (fresh) air position are not selected automatically, press the corresponding button manually.

To defrost outside windshield

Kia Soul. Manual climate control system

1. Set the fan speed to the highest (extreme right) position.

2. Set the temperature to the extreme hot position.

3. Select the Kia Soul. Manual climate control system position.

4. The outside (fresh) air and air conditioning will be selected automatically.

    WARNING Windshield heating Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility.

    To defog inside windshield 1. Set the fan speed to the desired position. 2. Select desired temperature. 3. Press the defroster button (). 4. The air conditioning will be turned on according to the detected ambient temperature and outside (fresh) air position will be selected automatically.

    Other information:

    Kia Soul (SK3) 2020-2025 Owners Manual: Wheel alignment and tire balance

    The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels aligned again. However, if you notice unusual tire wear or your vehicle pulling one way or the other, the alignment may need to be reset.

    Kia Soul (SK3) 2020-2025 Owners Manual: Tail lamp / Back up lamp bulb replacement (Rear combination lamp Type A)

    1. Open the tailgate. 2. Remove the service cover. (Loosen the lamp assembly retaining screws and remove the lamp assembly from the body of the vehicle for back-up lamp) 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.

    Categories

     
    Copyright © 2026 www.ksoulsk3.com - 0.0073