Kia Soul (SK3): Windshield defrosting and defogging / Manual climate control system

To defog inside windshield

Kia Soul. Manual climate control system

1. Select any fan speed except “0” position.

2. Select desired temperature.

3. Select the Kia Soul. Manual climate control system or Kia Soul. Manual climate control system position.

4. The outside (fresh) air and air conditioning will be selected automatically.

If the air conditioning and outside (fresh) air position are not selected automatically, press the corresponding button manually.

To defrost outside windshield

Kia Soul. Manual climate control system

1. Set the fan speed to the highest (extreme right) position.

2. Set the temperature to the extreme hot position.

3. Select the Kia Soul. Manual climate control system position.

4. The outside (fresh) air and air conditioning will be selected automatically.

    WARNING Windshield heating Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility.

    To defog inside windshield 1. Set the fan speed to the desired position. 2. Select desired temperature. 3. Press the defroster button (). 4. The air conditioning will be turned on according to the detected ambient temperature and outside (fresh) air position will be selected automatically.

    Other information:

    Kia Soul (SK3) 2020-2025 Owners Manual: Explanation of scheduled maintenance items

    Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the car is being driven in severe conditions, more frequent oil and filter changes are required. Drive belts Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil saturation and replace if neces

    Kia Soul (SK3) 2020-2025 Owners Manual: Stop/tail and turn signal lamp (Bulb type) bulb replacement (Rear combination lamp Type A)

    1. Open the tailgate. 2. Loosen the lamp assembly retaining screws with a screwdriver. 3. Remove the rear combination lamp assembly from the body of the vehicle. 4. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.

    Categories

     
    Copyright © 2026 www.ksoulsk3.com - 0.0118