Kia Soul: Reverse Parking Distance Warning (PDW-R) system / Operation of Reverse Parking Distance Warning system
Operating condition
- This system will activate when the indicator on the Reverse Parking Distance
Warning system OFF button is not illuminated. If you desire to deactivate Reverse
Parking Distance Warning system, press the Reverse Parking Distance Warning
system OFF button again. (The indicator on the button will illuminate.) To turn
the system on, press the button again. (The indicator on the button will go
off.)
- This system will activate when backing up with the ignition switch ON.
If the vehicle is moving at a speed over 5 km/h (3 mph), the system may not
be activated correctly.
- The sensing distance while Reverse Parking Distance Warning system is
in operation is approximately 120 cm (47 in.).
- When more than two objects are sensed at the same time, the closest one
will be recognized first.


NOTICE
The indicator may differ from the illustration as objects or sensors status.
If the indicator blinks, have the system checked by a professional workshop.
Kia recommends to visit an authorized Kia dealer/service partner.
Reverse Parking Distance Warning system assists the driver during backward movement of the vehicle by chiming if any object is sensed within a distance of 120 cm (47 in.) behind the vehicle. This system ...
Reverse Parking Distance Warning system may not operate properly when: 1. Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2. The sensor is covered with ...
Other information:
Ventilation 1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed control to the desired speed. Heating 1. Set the mode to the position. 2. Set the air intake control to the outside ...
1. Remove the lamp assembly by using a flat-blade screwdriver. 2. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 3. Remove the bulb from bulb-socket by pulling it out. 4. Insert a new bulb by inserting it ...