Kia Soul: Light bulbs / Position lamp/DRL/Front turn signal lamp bulb replacement (Type A, B)

1. Open the hood.
2. Remove the bulb socket-connector by turning it counterclockwise.
3. Remove the bulb from the lamp assembly.
4. Install a new bulb.
5. Connect the bulb socket-connector.
Headlamp bulb

WARNING
Halogen bulbs
- Halogen bulbs contain pressurized gas that will produce flying pieces
of glass if broken.
- Always handle them carefully, and avoid scratches and abrasions. If
the bulbs are lit, avoid contact with liquids. Never touch the glass with bare
hands. Residual oil may cause the bulb to overheat and burst when lit. A bulb
should be operated only when installed in a headlight.
- If a bulb becomes damaged or cracked, replace it immediately and carefully
dispose of it.
- Wear eye protection when changing a bulb. Allow the bulb to cool down
before handling it.
If the Headlamp (High/Low) (1) does not operate, have your vehicle checked by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner. ...
If the position lamp + DRL (LED) (1) does not operate, have your vehicle checked by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner. The LED lamps cannot be replaced ...
Other information:
The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Warranty & Maintenance book in your vehicle. Your vehicle is equipped with an emission control system to meet all emission regulations. There are three emission ...
Blind-Spot Collision Warning (BCW) system uses a radar sensor to alert the driver while driving. It senses the rear side territory of the vehicle and provides information to the driver. - Blind Spot Area Warning range is dependent on your vehicle speed. However, if the speed of your vehicle is faster ...