Kia Soul: What to do in an emergency / If you have a flat tire (with spare tire)
Jack and tools

The jack, jack handle, wheel lug nut wrench are stored in the luggage compartment.
Pull up the luggage box cover to reach this equipment.
1. Jack handle
2. Jack
3. Wheel lug nut wrench
Jacking instructions
The jack is provided for emergency tire changing only.
To prevent the jack from “rattling” while the vehicle is in motion, store it
properly.
Follow jacking instructions to reduce the possibility of personal injury.
WARNING
Changing tires
- Never attempt vehicle repairs in the traffic lanes of a public road
or highway.
- Always move the vehicle completely off the road and onto the shoulder
before trying to change a tire. The jack should be used on level firm ground.
If you cannot find a firm, level place off the road, call a towing service company
for assistance.
- Be sure to use the correct front and rear jacking positions on the
vehicle; never use the bumpers or any other part of the vehicle for jacking
support.
- The vehicle can easily roll off the jack causing serious injury or
death.
- Do not get under a vehicle that is supported by a jack.
- Do not start or run the engine while the vehicle is on the jack.
- Do not allow anyone to remain in the vehicle while it is on the jack.
- Make sure any children present are in a secure place away from the
road and from the vehicle to be raised with the jack.
If you have a flat tire, the low Tire Pressure and Position telltales will come on. In this case, have the system checked by a professional workshop. Kia recommends to visit an authorized Kia dealer/service ...
Turn the tire hold-down wing bolt counterclockwise to remove. Store the tire in the reverse order of removal. To prevent the spare tire and tools from “rattling” while the vehicle is in motion, store ...
Other information:
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer. 1. HI / 2 - Normal wiper operation 2. LO / 1 - Intermittent wiper operation (if equipped) 3. OFF / O - Wiper is not in operation ...
The LCD Display modes can be changed by using the control buttons on the steering wheel. 1. : MODE button for change the LCD MODES 2.: MOVE scroll switch for select the items 3. OK : SET/REST button for set the items or reset the items ❈ For the LCD modes, refer to “LCD Display” on page 4-51. ...