Kia Soul (SK3): Specifications & Consumer information / Declaration of conformity. Fuel Label

Declaration of conformity

Kia Soul. Declaration of conformity. Fuel Label

The radio frequency components of the vehicle comply with requirements and other relevant provisions of Directive 1995/5/EC.

Further information including the manufacturer's declaration of conformity is available on Kia web site as follows;

http://www.kia-hotline.com

Fuel Label

Gasoline (Petrol) engine

Kia Soul. Declaration of conformity. Fuel Label

The fuel label is attached on the fuel filler door.

A- Octane rating of unleaded Gasoline (Petrol)
1. RON/ROZ : Research Octane Number
2. (R+M)/2, AKI : Anti Knock Index

B- Identifiers for Petrol-type fuels

❈ This symbol means usable fuel. Do not use any other fuel.

C- For further details, refer to “Fuel Requirements” on page 1-03.

Diesel engine

Kia Soul. Declaration of conformity. Fuel Label

The fuel label is attached on the fuel filler door.

A- Fuel : Diesel

B- Identifiers for FAME containing Diesel- type Fuels

❈ This symbol means usable fuel. Do not use any other fuel.

C- For further details, refer to “Fuel Requirements” on page 1-03.

    Air conditioner compressor label A compressor label informs you the type of compressor your vehicle is equipped with such as model, supplier part number, production number, refrigerant (1) and refrigerant oil (2).

    Other information:

    Kia Soul (SK3) 2020-2025 Owners Manual: Distributing the sealant

    11. Immediately drive approximately 7~10 km (4~6 miles or, about 10min) to evenly distribute the sealant in the tire. CAUTION Do not exceed a speed of 80 km/h (50 mph). If possible, do not fall below a speed of 20 km/h (12 mph). While driving, if you experience any unusual vibration, ride disturbance or noise, reduce your speed and drive wi

    Kia Soul (SK3) 2020-2025 Owners Manual: Tailgate room lamp replacement

    1. Using a flat-blade screwdriver, gently pry the lens cover from lamp housing. 2. Remove the bulb by pulling it straight out. 3. Install a new bulb in the socket. 4. Align the lens cover tabs with the lamp housing notches and snap the lens into place.

    Categories

     
    Copyright © 2025 www.ksoulsk3.com - 0.0083