
In order for FCA system to operate properly, always make sure the sensor is clean and free of dirt, snow, and debris.
Dirt, snow, or foreign substances on the lens may adversely affect the sensing performance of the sensor.
Warning message and warning light

When the camera is blocked with dirt, snow, or debris, FCA operation may temporarily stop. In this case, the warning message appears to warn the driver.
This is not a malfunction with FCA. To operate FCA again, remove the foreign substances.
WARNING
FCA system may not activate without any warning messeges according to driving condition, traffic on the road, weather, road condition, etc.
NOTICE
In an urgent situation, the braking system enters into the ready status for prompt reaction to assist the driver in depressing the brake pedal. FCA provides additional braking power for optimum braking performance, when the driver depresses the brake pedal during FCA operation.
When FCA is not working properly, FCA warning light () will illuminate and the warning message will appear for a few seconds. After the message disappears, the master warning light () will illuminate.
All tire pressures (including the spare) should be checked when the tires are cold. “Cold Tires” means the vehicle has not been driven for at least three hours or driven less than 1.6 km (1 mile). Recommended pressures must be maintained for the best ride, top vehicle handling, and minimum tire wear.
Inside the fuse/relay panel covers, you can find the fuse/relay label describing fuse/relay name and capacity. NOTICE Not all fuse panel descriptions in this manual may be applicable to your vehicle. It is accurate at the time of printing. When you inspect the fuse panel in your vehicle, refer to the fuse panel label.