
When the "Check System" warning message appears, the system is not working properly. In this case, have the system checked by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.
WARNING
NOTICE
Driver Attention Warning system utilizes the camera sensor on the front windshield for its operation. To keep the camera sensor in the best condition, you should observe the followings:
- Do not disassemble camera temporarily for tinted window or attaching any
types of coatings and accessories. If you disassemble a camera and assemble it again,
have the system checked by a professional workshop. Kia recommends to visit an authorized
Kia dealer/service partner and have the system checked to need a calibration.
- Do not locate any reflective objects (i.e. white paper, mirror) over the dashboard.
Any light reflection may cause a mal-function of Driver Attention Warning (DAW)
system.
- Pay extreme caution to keep the camera sensor out of water.
- Do not arbitrarily disassemble the camera assembly, nor apply any impact on the
camera assembly.
• Playing the vehicle audio system at high volume may offset Driver Attention Warning system warning sounds.
CAUTION
Driver Attention Warning system may not properly operate with limited alerting in the following situations:
Resetting the system The last break time is set to 00:00 and the driver's attention level is set to 5 (very attentive) when the driver resets Driver Attention Warning system.
The drive mode may be selected according to the driver's preference or road condition. The mode changes whenever the DRIVE MODE button is pressed.
1. Engine coolant reservoir 2. Engine oil filler cap 3. Brake/clutch fluid reservoir 4. Air cleaner 5. Fuse box 6. Negative battery terminal 7. Positive battery terminal 8. Engine oil dipstick 9. Radiator cap 10. Windshield washer fluid reservoir 1.
If the map lamp (LED) (1), does not operate, have your vehicle checked by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner. The LED lamps cannot be replaced as a single unit because it is an integrated unit.