Kia Soul: If you have a flat tire (with Tire Mobility Kit) / Components of the Tire Mobility Kit (TMK)
1. Speed restriction label
2. Sealant bottle and label with speed restriction
3. Filling hose from sealant bottle to wheel
4. Connectors and cable for the battery direct connection
5. Holder for the sealant bottle
6. Compressor
7. On/off switch
8. Pressure gauge for displaying the tire inflation pressure
9. Button for reducing tire inflation pressure
10. Hose to connect compressor and sealant bottle or compressor and wheel
Connectors, cable and connection hose are stored in the compressor housing.
WARNING
Expired sealant
Do not use the tire sealant after the sealant has expired (i.e. pasted the expiration date on the sealant container). This can increase the risk of tire failure.
WARNING
Sealant
- Keep out of reach of children.
- Avoid contact with eyes.
- Do not swallow.
Strictly follow the specified sequence, otherwise the sealant may escape under high pressure.
Introduction
With the Tire Mobility Kit (TMK) you stay mobile even after experiencing a tire puncture. The system of compressor and sealing compound effectively and comfortably seals most punctures in a passenger ...
Using the TMK
1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast. ...
Other information:
Kia Soul (SK3) 2020-2023 Owners Manual: Headlamp and front fog lamp aiming
Headlamp aiming Front fog lamp aiming 1. Horizontal aiming 2. Vertical aiming 3. Low vertical aiming 4. High vertical aiming 5. Vertical aiming (Front) 6. Vertical aiming (Low) 1. Inflate the tires to the specified pressure and remove any loads from the vehicle except the driver, spare tire, and tools. ...
Kia Soul (SK3) 2020-2023 Owners Manual: Side repeater lamp (Bulb type) bulb replacement
1. Remove the lamp assembly from the vehicle by prying the lens and pulling the assembly out. 2. Disconnect the bulb electrical connector. 3. Separate the socket and the lens parts by turning the socket counterclockwise until the tabs on the socket align with the slots on the lens part. 4. Remove the ...
