
The light switch has a Headlight and a Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of the following positions:
1. Off position
2. Auto light position (if equipped)
3. Parking light position
4. Headlight position
Parking light position


When the light switch is in the parking light position (2nd position), the tail position, license and instrument panel lights will turn ON.
Headlight position


When the light switch is in the headlight position (3rd position), the head, tail, position, license and instrument panel lights are ON.
NOTICE
The ignition switch must be in the ON position to turn on the headlights.
Auto light position

When the light switch is in the AUTO light position, the taillights and headlights will be turned ON or OFF automatically depending on the amount of light outside the vehicle.
CAUTION
When the headlight switch is in the ON or AUTO position and all doors (and tailgate) are closed and locked, if you press the door unlock button on the transmitter (or smart key), the headlights will come on for about 15 seconds.
To turn on the high beam headlights, push the lever away from you. Pull it back for low beams. The high beam indicator will light when the headlight high beams are switched on.
Checking the brake/clutch fluid level Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir. Before removing the reservoir cap and adding brake/clutch fluid, clean the area around the reservoir cap thoroughly to prevent brake/clutch fluid contamination.
1. Open the tailgate. 2. Loosen the lamp assembly retaining screws with a screwdriver. 3. Remove the rear combination lamp assembly from the body of the vehicle. 4. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.