Battery saver function
If necessary, to keep the lights on when the ignition key is removed, (smart key: turns off the engine) perform the following:
1. Open the driver-side door.
2. Turn the parking lights OFF and ON again using the light switch on the steering column.
Rear View Monitor system will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R (Reverse) position. This system is a supplemental system that shows behind the vehicle through the navigation display while backingup.
The headlights (and/or taillights) will remain on for approximately 5 minutes after the ignition key is removed when the engine is turned off. However, if the driver’s door is opened and closed, the headlights are turned off after 15 seconds.
Please prepare bulbs with appropriate standards in case of emergencies (Refer to “Bulb wattage” on page 9-07 for further information). When changing bulbs and sorts, first turn off the engine at a safe place, firmly apply the side brake and take out the battery's negative (-) terminal.
1. Using a flat-blade screwdriver, gently pry the lamp assembly from interior. 2. Remove the bulb by pulling it straight out. 3. Install a new bulb in the socket. 4. Install the lamp assembly to interior. CAUTION Be careful not to dirty or damage the lens, lens tab, and plastic housings.