Battery saver function
If necessary, to keep the lights on when the ignition key is removed, (smart key: turns off the engine) perform the following:
1. Open the driver-side door.
2. Turn the parking lights OFF and ON again using the light switch on the steering column.
Rear View Monitor system will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R (Reverse) position. This system is a supplemental system that shows behind the vehicle through the navigation display while backingup.
The headlights (and/or taillights) will remain on for approximately 5 minutes after the ignition key is removed when the engine is turned off. However, if the driver’s door is opened and closed, the headlights are turned off after 15 seconds.
1. Speed restriction label 2. Sealant bottle and label with speed restriction 3. Filling hose from sealant bottle to wheel 4. Connectors and cable for the battery direct connection 5. Holder for the sealant bottle 6. Compressor 7. On/off switch 8.
1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast. 2. Screw connection hose (10) onto the connector of the sealant bottle.