Kia Soul: Light bulbs / Stop/tail and turn signal lamp (Bulb type) bulb replacement (Rear combination lamp Type A)

Kia Soul (SK3) 2020-2022 Owners Manual / Maintenance / Light bulbs / Stop/tail and turn signal lamp (Bulb type) bulb replacement (Rear combination lamp Type A)

Kia Soul. lamp Type A)

1. Open the tailgate.

2. Loosen the lamp assembly retaining screws with a screwdriver.

3. Remove the rear combination lamp assembly from the body of the vehicle.

Kia Soul. lamp Type A)

4. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.

5. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the socket.

6. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.

7. Install the socket in the assembly by aligning the tabs on the socket with the slots in the assembly and turning the socket clockwise.

8. Reinstall the lamp assembly to the body of the vehicle.

Side repeater lamp (Bulb type) bulb replacement

1. Remove the lamp assembly from the vehicle by prying the lens and pulling the assembly out. 2. Disconnect the bulb electrical connector. 3. Separate the socket and the lens parts by turning the socket ...

Tail lamp / Back up lamp bulb replacement (Rear combination lamp Type A)

1. Open the tailgate. 2. Remove the service cover. (Loosen the lamp assembly retaining screws and remove the lamp assembly from the body of the vehicle for back-up lamp) 3. Remove the socket from the ...

Other information:

Kia Soul (SK3) 2020-2022 Owners Manual: Seat cushion height. Lumbar support

Seat cushion height 1. Pull the front portion of the control switch up to raise or press down to lower the front part of the seat cushion. Pull the rear portion of the control switch up to raise or press down to lower the seat cushion. 2. Release the switch once the seat reaches the desired position. ...

Kia Soul (SK3) 2020-2022 Owners Manual: Electronic stability control (ESC) indicator light, Electronic stability control (ESC) OFF indicator light

Electronic stability control (ESC) indicator light This indicator light illuminates: • Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. • When there is a malfunction with the ESC system. In this case, ...