Kia Soul (SK3): Safety features of your vehicle / Air bag - supplemental restraint system

Kia Soul. Air bag - supplemental restraint system

1. Driver’s front air bag
2. Passenger’s front air bag*
3. Side air bag*
4. Curtain air bag*
5. Passenger’s front air bag ON/OFF switch*

WARNING

  • Even in vehicles with air bags, you and your passengers must always wear the safety belts provided in order to minimize the risk and severity of injury in the event of a collision or in most rollover situations. • SRS and pretensioners contain explosive chemicals.
  • If scraping a vehicle without removing SRS and pretensioners from a vehicle, it may cause fire. Before scraping a vehicle, contact a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.
  • Keep the SRS parts and wirings away from water or any liquid. If the SRS components are inoperative due to exposure to water or liquids, it may cause fire or severe injury.

(Information for vehicle users and CRS manufacturers) Yes : Suitable for fitment of the designated category of CRS No : Not suitable for fitment of the designated category of CRS “-” : Not applicable The table is based on LHD vehicle.

Air bags are activated (able to inflate if necessary) only when the ignition switch is turned to the ON or START position. Air bags inflate instantly in the event of serious frontal or side collision (if equipped with side air bag or curtain air bag) in order to help protect the occupants from serious physical injury.

Other information:

Kia Soul (SK3) 2020-2025 Owners Manual: Recommended cold tire inflation pressures

All tire pressures (including the spare) should be checked when the tires are cold. “Cold Tires” means the vehicle has not been driven for at least three hours or driven less than 1.6 km (1 mile). Recommended pressures must be maintained for the best ride, top vehicle handling, and minimum tire wear.

Kia Soul (SK3) 2020-2025 Owners Manual: Tailgate room lamp replacement

1. Using a flat-blade screwdriver, gently pry the lens cover from lamp housing. 2. Remove the bulb by pulling it straight out. 3. Install a new bulb in the socket. 4. Align the lens cover tabs with the lamp housing notches and snap the lens into place.

Categories

 
Copyright © 2026 www.ksoulsk3.com - 0.0093