Kia Soul (SK3): Automatic climate control system / Front glass heater

Kia Soul. Front glass heater

The front glass heater heats the window to remove frost, fog and thin ice from the interior and exterior of the front window, while the engine is running.

To activate the front glass heater, press the front glass heater button. The indicator on the front glass heater button illuminates when the front glass heater is ON.

If there is heavy accumulation of snow on the front window, brush it off before operating the front glass heater.

The front glass heater automatically turns off after approximately 15 minutes or when the ignition switch is turned off. However, if you press the button again after the heater is turned off automatically after 15 minutes, the heater will stay on only for 5 minutes. To turn off the front glass heater while it is operating, press the front glass heater button again.

OFF mode

Kia Soul. Front glass heater

Press the OFF button to turn off the air climate control system. However, you can still operate the air intake buttons as long as the ignition switch is in the ON position.

    Fan speed control The fan speed can be set to the desired speed by operating the fan speed control knob. The higher the fan speed is, the more air is delivered.

    Ventilation 1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position.

    Other information:

    Kia Soul (SK3) 2020-2025 Owners Manual: Battery recharging

    Your vehicle has a maintenance-free, calcium-based battery. If the battery becomes discharged in a short time (because, for example, the headlights or interior lights were left on while the vehicle was not in use), recharge it by slow charging (trickle) for 10 hours.

    Kia Soul (SK3) 2020-2025 Owners Manual: Map lamp (Bulb type) bulb replacement

    WARNING Prior to working on the Interior lamps, ensure that the “OFF” button is depressed to avoid burning your fingers or receiving an electric shock. 1. Using a flat-blade screwdriver, gently pry the lens cover from lamp housing. 2. Remove the bulb by pulling it straight out.

    Categories

     
    Copyright © 2025 www.ksoulsk3.com - 0.0102