Kia Soul (SK3): Maintenance / Climate control air filter
Filter inspection
If the vehicle is operated in the severely air-polluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier. When you, the owner, replace the climate control air filter, replace it performing the following procedure, and be careful to avoid damaging other components.
Replace the filter according to the Maintenance Schedule.
Filter replacement
1. Open the glove box.
2. With the glove box open, pull the support strap (1).
3. Push in Both sides (2) of the glove box as shown. This will ensure that the glove box stopper pins will get released from its holding location allowing the glove box to hang.
4. Remove the climate control air filter case by pulling out both sides of the cover.
5. Replace the climate control air filter.
6. Reassemble in the reverse order of disassembly.
NOTICE
When replacing the climate control air filter install it properly. Otherwise, the system may produce noise and the effectiveness of the filter may be reduced.
Filter replacement It must be replaced when necessary, and should not be washed. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compressed air.
Blade inspection NOTICE Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean. Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wipers.
Other information:
Kia Soul (SK3) 2020-2025 Owners Manual: Removing and storing the spare tire
Turn the tire hold-down wing bolt counterclockwise to remove. Store the tire in the reverse order of removal. To prevent the spare tire and tools from “rattling” while the vehicle is in motion, store them properly. WARNING Ensure the spare tire retainer is properly aligned with the center of the spare tire to prevent the spare tire f
Kia Soul (SK3) 2020-2025 Owners Manual: Stop/tail and turn signal lamp (Bulb type) bulb replacement (Rear combination lamp Type A)
1. Open the tailgate. 2. Loosen the lamp assembly retaining screws with a screwdriver. 3. Remove the rear combination lamp assembly from the body of the vehicle. 4. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.
Categories
- Manuals Home
- Kia Soul Owners Manual
- Smooth cornering, Driving at night
- Temperature control, Max A/C selection
- Shift lock system
- New on site
- Most important about car
