

1. Front turn signal lamp (Bulb Type)
2. Headlamp (Low/High)
3. Position lamp/Daytime running lamp (Bulb Type)
4. Front turn signal lamp (LED Type)
5. Headlamp (LED)/Sub Low
6. Headlamp (LED) (Low)
7. Position lamp/Daytime running lamp (LED Type)
8. Front fog lamp (LED Type)
9. Front fog lamp (Bulb Type)
Please prepare bulbs with appropriate standards in case of emergencies (Refer to “Bulb wattage” on page 9-07 for further information). When changing bulbs and sorts, first turn off the engine at a safe place, firmly apply the side brake and take out the battery's negative (-) terminal.
1. Tail lamp (Bulb type) 2. Tail and stop lamp (Bulb type) 3. Rear turn signal lamp (Bulb type) 4. Back-up lamp (Bulb type) 5. Tail lamp (LED type) 6.
Checking the washer fluid level Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use washer solvent with antifreeze characteristics in cold climates to prevent freezing.
1. Using a flat-blade screwdriver, gently pry the lamp assembly from interior. 2. Remove the bulb by pulling it straight out. 3. Install a new bulb in the socket. 4. Install the lamp assembly to interior. CAUTION Be careful not to dirty or damage the lens, lens tab, and plastic housings.