Kia Soul (SK3): Maintenance / Wiper blades. Blade replacement

Kia Soul (SK3) 2020-2025 Owners Manual / Maintenance / Wiper blades. Blade replacement

Blade inspection

Kia Soul. Wiper blades

NOTICE

Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean.

Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wipers. Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial car washes. If the blades are not wiping properly, clean both the window and the blades with a good cleaner or mild detergent, and rinse thoroughly with clean water.

CAUTION

To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near them.

Blade replacement

When the wipers no longer clean adequately, the blades may be worn or cracked, and require replacement.

CAUTION

To prevent damage to the wiper arms or other components, do not attempt to move the wipers manually.

CAUTION

The use of a non-specified wiper blade could result in wiper malfunction and failure.

Front windshield wiper blade

Kia Soul. Blade replacement

Type A

1. Raise the wiper arm and turn the wiper blade assembly to expose the plastic locking clip.

CAUTION

Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.

Kia Soul. Blade replacement

2. Compress the clip and slide the blade assembly downward.

3. Lift it off the arm.

4. Install the blade assembly in the reverse order of removal.

Kia Soul. Blade replacement

Type B

1. Raise the wiper arm.

2. Lift up the wiper blade clip. Then pull down the blade assembly and remove it.

3. Install the new blade assembly.

4. Return the wiper arm on the windshield.

5. Turn ignition to the ON position and wiper arms will return to the normal operating position.

Rear window wiper blade

Kia Soul. Blade replacement

1. Raise the wiper arm and pull out the wiper blade assembly.

Kia Soul. Blade replacement

2. Install the new blade assembly by inserting the center part into the slot in the wiper arm until it clicks into place.

3. Make sure the blade assembly is installed firmly by trying to pull it slightly.

To prevent damage to the wiper arms or other components, have the wiper blade replaced by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

    Filter inspection If the vehicle is operated in the severely air-polluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier.

    For best battery service Keep the battery securely mounted. Keep the battery top clean and dry. Keep the terminals and connections clean, tight, and coated with petroleum jelly or terminal grease.

    Other information:

    Kia Soul (SK3) 2020-2025 Owners Manual: Checking the tire inflation pressure

    1. After driving approximately 7~10 km ( 4~6 miles or about 10 minutes), stop at a suitable location. 2. Connect connection hose (10) of the compressor directly to the tire valve. 3. Connect between compressor and the vehicle power outlet using the cable and connectors.

    Kia Soul (SK3) 2020-2025 Owners Manual: Emergency commodity

    There are some emergency commodities in the vehicle to help you respond to the emergency situation. Fire extinguisher If there is small fire and you know how to use the fire extinguisher, take the following steps carefully. 1. Pull the pin at the top of the extinguisher that keeps the handle from being accidentally pressed.

    Categories

     
    Copyright © 2026 www.ksoulsk3.com - 0.0126